Welcome to the von Karman Institute for Fluid Dynamics Store

XIX Biannual symposium on measuring techniques in turbomachinery

Be the first to review this product

Availability: In stock

€60.00
OR

Quick Overview

XIX Biannual symposium on measuring techniques in turbomachinery, ISBN 978-2-930389-32-X

XIX Biannual symposium on measuring techniques in turbomachinery

Double click on above image to view full picture

Zoom Out
Zoom In

More Views

  • XIX Biannual symposium on measuring techniques in turbomachinery
  • XIX Biannual symposium on measuring techniques in turbomachinery

Details

XIX Biannual symposium on measuring techniques in turbomachinery
April 7-8, 2008; edited by G. Paniagua
ISBN 978-2-930389-32-X
Table of contents

Session on Optical Measurements
Chairman: C.H. Sieverding

  • Development of a 1-camera Doppler Global Velocimeter: first measurement in around free jet
    J.A.C. Berthiau, S. Goguey, X. Ottavy
  • PIV measurement of the vortical structures in rotating channels
    A. Di Sante, R.A. Van den Braembussche
  • PIV application to transonic axial and radial compressors
    M. Voges, C. Willert, M.W. Müller
  • Tunable diode laser absorption spectroscopy and its application in an impulse hypervelocity facility
    J. M. Meyers
  • Methodology to implement PSP technique in a transient facility
    J. Michalek, G. Paniagua, M. Vergalla, N. Zerelli, M. Tulkens
  • Combined high speed stereoscopic PIV measurements and unsteady pressure measuerements in the vaneless diffuser of a centrifugal pump
    A. Dazin, S. Coudert, P. Dupont, G. Caignaert, G. Bois
  • Study of coherent structures in coaxial jet noise using PIV
    B.H. Timmerman, J.P. Bryanston-Cross

Session on Tip clearance and Tip timing
Chairman: X. Ottavy

  • Metrology considerations for calibrating turbine tip clearance sensors
    J.L. Geisheimer, T.A. Holst
  • Single blade tip clearance measurements in a transient rig
    M. Tulkens, G. Paniagua, A. Steiner
  • Turbomachinery blades spectral estimation from tip-timing data
    C. Stephan, M. Berthillier, J. Lardies, A. Talon
  • Assessment of the reassignment technique applied to vibratory diagnosis on turbomachinery
    G. Pargade, A. Talon

Session on MEMS, fast prototyping, new rigs
Chairman: G. Pavesi

  • SOI-CMOS MEMS wall shear stress sensors
    I. Haneef, S.Z. Ali, F. Udrea, J.D. Coull, H.P. Hodson
  • The corona mass flow meter
    F. Laurantzon, N. Tillmark, P.H. Alfredsson
  • Efficiency measurement in the QinetiQ turbine test facility with temperature distortion and swirl: the mass flow rate measurement problem
    P. Beard, T. Povey
  • Rapid prototyping for wind tunnel testing and instrumentation
    R. Thomas, H. Hodson
  • Main factors of application of active methods of the boundary layer control to the compressor blade cascade flow
    M. Matejka, P. Safarik
  • Experimental study of the efflux of an aero-engine in post-combustion regime: influence of the environmental conditions
    P. Vyvey, W. Bosschaerts, R. Wagemakers

Session on Pressure Measurements
Chairman: P. Safarik

  • Effects of a rotating aerodynamic probe on the flow field of a compressor rotor
    J. Lepicovsky
  • Probes in transonic flow
    F. Kost
  • Three-hole pressure probes at large
    K.M. Argüelles Díaz, J.M. Fernandez Oro, E. Blanco Marigorta
  • Estimation of turbulence by single-hole pressure probes
    G. Persico, P. Gaetani, B. Paradiso
  • Characterization and first application of a thin-film electret unsteady pressure measurement technique
    D.M. Vogt, J.E. Fridh, T.H. Fransson

Heat Flux and Temperature Measurements
Chairman: H. Hodson

  • A post processing procedure for the evaluation of adiabatic and overall effectiveness of effusion cooling geometries
    B. Facchini, L. Tarchi, L. Toni
  • Application of the transient heater foil technique for heat transfer measurements
    M. Jonsson, P. Ott
  • Novel calibration method for an infrared thermography system applied to heat transfer experiments in hot channels
    M. Ochs, A. Schulz, H.-J. Bauer
  • A software module for correcting pyrometer measured temperatures
    M.F.G. Cremers, R.A. Rooth

Session on Data processing techniques
Chairman: G. Persico

  • A time-frequency post-processing technique for the characterization of the unsteady phenomena in the turbomachines
    G.Pavesi, G. Cavazzini, G. Ardizzon
  • An integrated tool for turbomachinery blading design and analysis
    P.K. Zachos, M. Pappa, G. Mansour, I. Tsiafis, A.I. Kalfas
  • Evaluation of blade cascade characteristics in experiments carried out with humid air
    N. Martin
  • Experimental setup for detailed secondary flow investigation by two-dimensional measurement of total pressure loss coefficients in compressor cascades
    K. Liesner, R. Meyer
  • Experimental investigation on the near-field aeroacoustic sources of a low speed axial fan
    S. Bianchi, A. Corsini, F. Rispoli, A.G. Sheard

Keynote

  • Application of Pressure Sensitive Paint for determination of the pressure field of aircraft models in wind tunnels
    Ch. Klein

Additional Information

Manufacturer von Karman Institute for Fluid Dynamics

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.